Dynojet Analog Module Manual do Utilizador descarregar pdf (Página 18)

Analog Module Installation and User Guide

CHAPTER 2

Analog Channel Configuration

2-6

EDITING A GAUGE

You will need to either create a new gauge or edit an existing gauge to represent your

analog channel. For this example, we will edit an existing gauge.

For more detailed information on creating a gauge, refer to the WinPEP 7 manual.

1 Verify you are in Advanced Mode. To change the user level click

To ols



Environment Options and click on the General tab.

2 If you are not already there, go to the MakeRun screen. Click the Make Run

button . The last template used is automatically loaded.

3Click the Edit Mode button . You cannot edit gauges unless you are in Edit

Mode.

4 Right click on the gauge and choose Gauge Properties.

5 The Gauge Property Editor dialog box will appear.

Each type of gauge has a slightly different dialog box, but most share the same

properties.

6 Select the analog channel you created earlier from the Data Channel drop down

list.

The analog channel selected automatically appears in the Upper Title and on the

gauge.

Note: You must be connected to the dyno electronics and the Analog Module

must be installed for the list of analog channels to be available.

7Click OK to enter these changes or click Cancel to abort the changes and return

to the MakeRun screen.

Figure 2-6: Gauge Property Editor Dialog Box

upper title

data channel

drop down list

1 2 ... 13 14 15 16 17 18 19 20 21

Sem comentários

Dynojet Analog Module Manual do Utilizador Página 18