Dynojet Optical RPM Sensor Manual do Utilizador descarregar pdf (Página 12)

Optical RPM Sensor Installation Guide

CHAPTER 1

Running WinPEP

1-6

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

RUNNING WINPEP

Use the following steps to run WinPEP, use the tachometer to verify the optical sensor

is functioning properly, and make a test run

Note: Depending on your version of WinPEP, the appearance of the windows and

messages may be slightly different than the ones used in this example.

STARTING WINPEP

1 Double-click the WinPEP icon on the desktop.

2Click the Make Run icon in the work space toolbar to display the Make Run

window.

Note: If the following error message is displayed, you will need to select a

different Com port (for DynoWare EX+) or a different address (for a PC Card).

2a Click OK to continue.

Figure 1-6: Error Message

2b The WinPEP Setup window will be displayed with the Dyno Parameters tab

automatically selected. Make any necessary corrections and click OK to

continue.

Figure 1-7: WinPEP Setup Window—Dyno Parameters

2c Once you have made your corrections, click the Make Run icon to display

the Make Run window.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Sem comentários

Dynojet Optical RPM Sensor Manual do Utilizador Página 12